Elantra GLS Wagon L4-2.0L (2000)
8.
Clean the mounting surface on top of the vehicle.
9.
Install the roof rack assembly, making sure the pads sit flush against the roof of the vehicle.
NOTE: The roof rack assembly is "side" specific. Make sure to install the correct side.
10.
Fasten the 12 mm roof rack mounting nuts from inside the vehicle. (Tightening torque is 15 Nm (150 kg.cm; 11 lb.ft.)).
11.
Reinstall the rubber patches over the holes in the roof liner panel.
NOTE: Contact cement, such as 3M's super weather-strip adhesive or equivalent, may be required if the rubber patches have lost their adhesion.
INSTALLATION OF HEAD LINER:
1.
Installation is the reverse of the removal procedure.
NOTE: *Roof Rack Mounting Pad Kits are included with each Roof Rack Assembly