Santa Fe L4-2.4L (2001)
29.
Hi-Scan Pro re-initializes the system.
30.
When the "ECM & TCM COMPLETED" message is displayed, the TCM reprogramming process is finished.
NOTES:
^
The new ECM and TCM IDs are displayed when the new TCM software download process is finished.
^
Before turning the Hi-Scan Pro OFF, check the new ECM & TCM IDs displayed on the Hi-Scan Pro screen to verify that the correct ECM and
TCM software have been downloaded.
^
Refer to the ECM and TCM specification table shown in this TSB.
31.
Start the engine to check for proper operation.
Manual Update Procedure
NOTE:
In the event that "01. SM 2.4 IDLE STUMBLE (AUTO)" fails to download the new ECM and TCM programs, option "02. SM 2.4 STUMBLE
(ERROR)" must be used.
Confirm all connections are established as shown in the "AUTOMATIC UPDATE PROCEDURE" before continuing.
1.
Be sure to start with the RED 10-pin connector.
2.
Turn the ignition to the ON position.
3.
Turn the Hi-Scan Pro ON and press ENTER.
