Santa Fe FWD V6-3.3L (2009)
6. Install the assist arm (A) and the trailing arm (B) to the rear axle carrier.
Tightening torque Nm (kgf-m, lb-ft) :
Bolt (C) : 137.3 - 156.9 (14 - 16, 101.3 - 115.7)
Nut (D) : 98.1 - 117.7 (10 - 12, 72.3 - 86.8)
Nut (E) : 137.3 - 156.9 (14 - 16, 101.3 - 115.7)
Bol t(F) : 137.3 - 156.9 (14 - 16, 101.3 - 115.7)
NOTE:
After checking the distance(465±10mm(18.31±0.39in)) between the wheel housing garnish(A) and the hub assembly(B) as shown in the
illustration, tighten the mounting bolts and nuts of rear chassis part with specified torque.
7. Install the rear shock absorber (A).
Tightening torque Nm (kgf-m, lb-ft) :
Bolt (B) : 137.3 - 156.9 (14 - 16, 101.3 - 115.7)
Nut (C) : 98.1 - 117.7 (10.0 - 12.0, 72.3 - 86.8)
8. Install the spring (A), the upper pad (B) and the lower pad (C).