Sonata GL V6-3.0L (1997)
CAUTION: Position the hooks in the tooth bottoms and apply he spindle to the back of the belt.
10. As the mounting bolts of the timing cover are different in size according to location, be sure to locate them according to the illustration.
Thread diameter x height
Bolts "A", 6 x 60 mm (0.24 x 2.36 inch).
Bolts "B", 6 x 20 mm (0.24 x 0.79 inch).
11. Install the crankshaft pulley on the crankshaft, then using the holder tool No. 09231-33200 and 09231-33300, or equivalent, tighten to 150-160
Nm (1,500-1,600 kg. cm, 108-116 ft. lbs.).
12. As the mounting bolts of the engine support bracket are different in size according to location, install them in the recommended sequence shown in
the illustration.
Thread diameter x height
Bolts numbered 1 and 5; 10 x 53 mm (0.39 x 2.09 inch).
Bolt numbered 2; 10 x 56 mm (0.47 x 2.20 inch).
Bolts numbered 3 and 4; 10 x 40 mm (0.39 x 1.57 inch).
NOTE:
-
When installing the reamer bolt, tighten it slowly while spraying in a suitable lubricant on the shouldered area.
-
To make the installation easier, raise the engine as necessary.
13. Install remaining removed components.
