Tiburon L4-2.0L (1999)
5. Tighten the bearing caps to the specified torque in two or three steps as shown.
Tightening torque:
Bearing cap bolt: 12 - 14 Nm (120 - 140 kg.cm, 9 - 10 ft. lbs.)
6. Using special tool, camshaft oil seal installer (09221-21000), press the camshaft oil seal. Be sure to apply engine oil to the external surface of the
oil seal. Insert the oil seal along the camshaft front end and install by driving the installer with a hammer until the oil seal is fully seated.
7. Install the camshaft sprocket to the specified torque.
Tightening torque:
Camshaft sprocket bolt: 80 - 100 Nm (800 - 1000 kg.cm, 60 - 74 ft. lbs.)
8. Align the camshaft sprocket and crankshaft sprocket timing marks. The piston in the No.1 cylinder will then be at top dead center on the
compression stroke.
9. Install the cylinder head cover.
Tightening torque:
Cylinder head cover bolts: 8 - 10 Nm (80 - 100 kg.cm, 6 - 7 ft. lbs.)
10. Install the spark plug cables, ignition coil assembly and cylinder head center cover.
