Tiburon L4-2.0L (1999)
Drive Belt: Adjustments
Alternator Belt Adjustment
CAUTION: If the belt is too loose, there will cause noise or premature wear. If the belt is too tight, the water pump bearing or the alternator will get
damaged.
1. Loosen the alternator support nut "A" and the tension adjuster lock bolt "B"
2. Using the tension adjuster bolt, adjust the belt tension to specification.
3. Tighten the adjuster lock bolt "B".
4. Tighten the alternator support nut "A".
5. Check the tension or the deflection of belt, readjust if necessary.
Tightening torque:
Alternator support nut A: 20 - 25 Nm (200 - 250 kg.cm, 14 - 18 ft. lbs.)
Adjuster bolt B: 12 - 15 Nm (120 - 150 kg.cm, 9 - 11 ft. lbs.)
Belt length: 975 +/- mm (34.4 +/- 0.2 inch)
