Tucson AWD L4-2.0L (2007)
10. After applying the specified fluid to the oil seal, install it in the rack housing, and fix the valve body assembly (A) and O-ring in the gear box (B).
11. Install the tab washer and the tie rod and stake the tab washer (A) end at two points over the tie rod.
NOTE:
1. Align the tab washer pawls with the rack grooves.
2. Always use a new tab washer
12. Install the bushing (A), rack support yoke (B), rack support spring (C), lock nut (E) and yoke plug (D) in the order shown in the illustration. Apply
semi-drying sealant to the threaded section of the yoke plug before installation.
13. With the rack placed in the center position, attach the yoke plug to the rack housing. Tighten the yoke plug to 15 Nm (1150 kgf-cm, 11 ft. lbs.).
Loosen the yoke plug approximately from 300 to600 and tighten the locking nut to the specified torque.
14. Tighten the feed tube to the specified torque and in stall the mounting rubber using adhesive.
