Tucson AWD L4-2.4L (2010)
-
Install the component with the specified torques.
-
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
CAUTION:
The VCM actuator has to be installed at the fully closing position of the VCM valve.
If it doesn't, the VCM coupling of the VCM shaft can't be put in the the VCM actuator.
1. Installation is reverse of removal.
Variable charge motion actuator installation bolt:
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)
