Tucson AWD L4-2.4L (2010)
4. Install the heater duct to the crash pad.
5. Install the crash pad.
6. Tighten the passenger airbag mounting bolt.
Tightening torque
: 18.6 - 26.5 Nm (1.9 - 2.7 kgf.m, 13.7 - 19.2 lb.ft)
7. Connect the passenger airbag harness connector to the SRS main harness connector.
8. Reinstall the glove box.
9. Reconnect the battery negative cable.
10. After installing the passenger airbag (PAB), confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
