Tucson AWD L4-2.4L (2010)
11. Using the SST(09495-3K000), secure the boot bands.
Clearance (A) :2.0 mm (0.079 in.) or less
12. To control the air in the VTJ boot, keep the specified distance between the boot bands when they are tightened.
Disassembly
Disassembly
CAUTION:
-
Do not disassemble the BJ assembly.
-
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
-
The boot band should be replaced with a new one.
1. Remove the TJ boot bands and pull the TJ boot from the TJ outer race.
(1) Using a pliers or flat-tipped (-) screwdriver, remove the LH boot band and LH TJ boot band from the driveshaft.
(2) Remove RH boot band and RH TJ boot band in the same way of LH removal procedure.
CAUTION:
Be careful not to damage the boot.
2. Pull out the driveshaft from the TJ outer race.
3. Remove the snap ring (A) and take out the inner race(B), cage(C) and balls(D) as an assembly.
