Tucson AWD V6-2.7L (2009)
7. Install the timing belt.
(1) Remove any oil or water on the sprockets, and keep them clean.
(2) Install the timing belt in this order.
Crankshaft sprocket(A) -> Idler pulley(B) -> Camshaft sprocket LH side(C) -> Water pump pulley(D) -> Camshaft sprocket RH side(E) ->
Tensioner pulley(F).
8. Remove the set pin(A) from the tensioner.
9. Timing belt tensioner checking.
(1) Rotate the crankshaft 2turns clockwise and measure the projected length of the auto tensioner at TDC(#1 compression stroke) after 5 minutes.
(2) The projected length should be 7 - 9mm (0.27 - 0.31in.)
10. Install the engine support bracket(A).
Tightening torque
B : 60 - 70Nm (6.0 - 7.0kgf.m, 43 - 51lb-ft)
C : 15 - 22Nm (1.5 - 2.2kgf.m, 11 - 16lb-ft)
