Tucson FWD V6-2.7L (2009)
Tire Pressure Sensor: Description and Operation
Description
1. MODE
(1) Normal Fixed Base State
2. Storage Auto State:
A. This state is a Low current consumption state.
B. Sensors are in this state when they first arrive at the dealership (either on the vehicle or as replacement spares).
C. In this state, the sensor does not measure pressure / temperature / battery level.
D. The sensor will not transmit in this state unless requested to do so by the initiate command.
3. Alert State:
A. The sensor automatically enters this state if the measured temperature exceeds 230 °F(110 °C) and over temperature shutdown is likely.
B. In this state, pressure is measured every 4 seconds and RF data transmitted every 4 seconds.
C. The state lasts for 1 minute if it is pressure triggered.
D. After state is else entered when a 3 psi change in pressure from the last RF transmission occurs.
NOTE:
Sensor mode is used to configure sensor between high line and low line system. TPM sensor of JM should be set to low line.
