Veracruz FWD V6-3.8L (2009)
5. Remove the RH front wheel.
6. Remove the under cover(A).
7. Remove the side cover.
8. Loosen the drain plug and drain the engine coolant.
9. Drain the engine oil.
10. Disconnect the ground cable (A) and loosen the power steering hose mounting bolt (B).
11. Remove the surge tank and engine wiring.
(1) Disconnect the RH front and rear oxygen sensor connectors(A), the power steering sensor connector(B), the RH injector harness connector(C)
and the VIS solenoid valve connector(D).
(2) Disconnect the RH ignition coil connector.
(3) Disconnect the OCV connector (A) and the knock sensor connector (B).
(4) Disconnect the LH front oxygen sensor connector (C).
(5) Disconnect the alternator connector (D) and the air compressor connector (E).
