Veracruz FWD V6-3.8L (2009)
11. To control the air in the PTJ boot, keep the specified distance between the boot bands when they are tightened.
12. Install the bands to both PTJ boots.
Inspection
Inspection
1. Check the driveshaft boots for damage and deterioration.
2. Check the ball joint for wear and damage.
3. Check the splines for wear and damage.
4. Check the dynamic damper for cracks, wear and position.
5. Check the driveshaft for cracks and wears.
Disassembly and Reassembly
Disassembly
CAUTION:
-
Do not disassemble the BJ assembly.
-
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
-
The boot band should be replaced with a new one.
1. Remove the circlip (B) from driveshaft splines (A) of the differential side TJ case.
