XG 350 V6-3.5L (2002)
1. Using a knife or the special tool (09861 - 31200), cut the old sealant smoothly to a thickness of about 2 mm (0.08 in.) on the bonding surface
around the entire rear window glass.
CAUTION: Be careful not to remove more adhesive than necessary, and also not to damage the paint- work on the body surface with the knife. If
the paintwork is damaged, repair the damaged area with touch-up paint.
2. Clean the body bonding surface with a sponge dampened in alcohol, or wax and grease remover.
3. Install the rear window lower molding mounting clip and rear window lower spacer.
4. If the old rear window is to be reinstalled, use a putty knife to scrape off all traces of old adhesive and the rubber dam, then clean the rear window
surface with alcohol where new adhesive is to be applied.
NOTE: Make sure the bonding surface is kept free of water, oil and grease.
CAUTION: Avoid setting the rear window on its edges; small chips may later develop into cracks.
5. Set the rear window, then center it in the opening.
Make alignment marks across the rear window and body with a grease pencil at the four points shown.