G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
2. Apply brake fluid to piston seal (1), and install them to cylinder body.
CAUTION:
Never reuse piston seal.
3. Apply rubber grease to piston boot (1). Cover the piston (2) end with piston boot, and then install cylinder side lip on piston boot securely into a
groove on cylinder body.
CAUTION:
Never reuse piston boot.
4. Apply brake fluid to piston (1). Push piston into cylinder body by hand and push piston boot (2) piston-side lip into the piston groove.
CAUTION:
Press the piston evenly and vary the pressing point to prevent cylinder inner wall from being rubbed.
5. Apply rubber grease to sliding pin and sliding pin boot, and install sliding pin and sliding pin boots to torque member.
6. Install bushing to cylinder body.
7. Install pad return springs and brake pads.
8. Install the cylinder body to the torque member and tighten the location pin and sliding pin bolt to the specified torque.
9. Install the protector.
Inspection
FRONT DISC BRAKE
BRAKE CALIPER ASSEMBLY (1 PISTON TYPE) : Inspection
INSPECTION AFTER DISASSEMBLY
Cylinder Body