G37x Coupe AWD V6-3.7L (VQ37VHR) (2009)
Seals and Gaskets: Service and Repair
Rear Final Drive R200
Exploded View
SIDE OIL SEAL
AWD : Exploded View
Removal And Installation
SIDE OIL SEAL
AWD : Removal and Installation
REMOVAL
1. Remove center muffler with a power tool. Refer to See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair/Exploded View.
2. Remove rear wheel sensor. Refer to See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service
and Repair/Wheel Sensor/Exploded View.
3. Remove drive shaft from final drive with a power tool. Then suspend it by wire, etc. Refer to See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Drive Shaft/Exploded View.
A : Attachment [SST: KV40104100 ( - )]
B : Sliding hammer [SST: ST36230000 (J-25840-A)]
4. Install attachment to side flange, and then pull out the side flange with the sliding hammer.
5. Remove side oil seal, using a suitable tool.