M35x AWD V6-3.5L (VQ35HR) (2010)
Engine Control Module: Testing and Inspection
Additional Service When Replacing Control Unit
Description
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
When replacing ECM, the following procedure must be performed.
Special Repair Requirement
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement
1.PERFORM INITIALIZATION OF IVIS (NATS) SYSTEM AND REGISTRATION OF ALL IVIS (NATS) IGNITION KEY IDS
See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and Repair.
- GO TO 2.
2.PERFORM VIN REGISTRATION
See: VIN Registration/Special Repair Requirement.
- GO TO 3.
3.PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING
See: Powertrain Management/Fuel Delivery and Air Induction/Testing and Inspection/Programming and Relearning/Accelerator Pedal Released
Position Learning/Special Repair Requirement.
- GO TO 4.
4.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Throttle Valve Closed Position
Learning/Special Repair Requirement.
- GO TO 5.
5.PERFORM IDLE AIR VOLUME LEARNING
See: Powertrain Management/Fuel Delivery and Air Induction/Testing and Inspection/Programming and Relearning/Idle Air Volume
Learning/Special Repair Requirement.
- GO TO 6.
6.PERFORM EXHAUST VALVE TIMING CONTROL LEARNING
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Exhaust Valve Timing Control
Learning/Special Repair Requirement.
- END