Ascender 2WD L6-4.2L (2003)
7. Pull the seat back cover up by releasing the hook and loop fastener strips (2).
8. Remove the hog rings (1) securing the cover to the pad.
9. Gently pull the pad away from the seat back frame. It may be glued in places from its original assembly.
10. Remove the head rest restraint guides by squeezing the tabs on the bottom of the guide together and pulling the guide upward out of the seat.
11. Remove the cover and pad from the seat back frame.
Installation Procedure
1. Position the pad on the seat back frame.
2. Fit the seat back cover over the top of the seat back frame and pad.
3. Install the head restraint guides by pushing them through the cover into the frame until the locking tabs snap into place. The guide with the locking
tab (1) installs on the right hand side of the seat.
4. Install the hog rings (1) to the cover and pad.
5. Pull the seat back cover down over the pad pressing the hook and loop fastener strips (2) together.
