i-290 2WD L4-2.9L (2008)
Coolant Reservoir: Service and Repair
Coolant Recovery Reservoir Replacement
Coolant Recovery Reservoir Replacement
Removal Procedure
1. Partially drain the coolant. Refer to Cooling System Draining and Filling (Static Fill) (See: Service and Repair/Cooling System Draining and
Filling (Static Fill))Cooling System Draining and Filling (Vac N Fill) (See: Service and Repair/Cooling System Draining and Filling (Vac N Fill)).
2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair) or Air Cleaner Assembly Replacement (See: Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair).
3. Remove the coolant overflow hose (6) from the coolant recovery reservoir (5).
4. Remove the bolt (4) securing the coolant recovery reservoir (5) to the coolant recovery reservoir bracket.
5. Remove the radiator vent hose from the coolant recovery reservoir.
6. Remove the bolt securing the coolant recovery reservoir (5) to the front wheel house panel.
7. Remove the coolant recovery reservoir.
Installation Procedure
1. Install the coolant recovery reservoir.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Install the retaining bolt to the front wheelhouse panel.
Tighten the bolt to 12 N.m (106 lb in).