i-350 L5-3.5L (2006)
9. Remove the cage and the inner race assembly (1) from the driveshaft bar (2).;
10. Remove the balls.
11. Remove the inner race from the cage.
12. Thoroughly degrease all parts.
13. Remove the seal and discard.
14. Clean the driveshaft bar, Use a wire brush to remove any remove any rust in the inner seal mounting areas (grooves).
Check the D/O joint housing for unusual wear, cracks, or other damage. Replace the assembly if any damaged parts are evident.
Installation Procedure
1. Install the new small retaining clamp (2) onto the neck of the inner seal (1).
2. Slide the small retaining clamp and inner seal to their proper position on the driveshaft bar (3).
Notice: Refer to Fastener Notice in Service Precautions.
3. Secure the small retaining clamp using J 35910 (or equivalent), a breaker bar, and a torque wrench.
^
Torque the small retaining clamp (1) to 136 Nm (100 ft. lbs.).
Important: The cage (4) is NOT symmetrical; the larger outside diameter is the bottom of the cage.
