i-350 L5-3.5L (2006)
Constant Velocity Joint: Service and Repair
Inner
Wheel Drive Shaft Inner Joint and Seal Replacement
^
Tools Required
-
J 35910 Drive Axle Seal Clamp Plier
-
J 8059 Snap Ring Pliers
Removal Procedure
Important: Before placing the driveshaft in a vise, place protective covers over the vise jaws.
1. Place the driveshaft in a vise.
Important: Do not damage the D/O joint housing while using the hand grinder.
2. Use a hand grinder to cut through the large retaining clamp (2) located at the D/O joint (1). Discard the large retaining clamp.
3. Use a hand grinder to cut through the small retaining clamp (4) on the small end of the inner seal (3). Discard the small retaining clamp.