I-Mark L4-1.8L 4FBI DSL (1982)
Fig. 37 Rocker arm shaft bolts installation sequence.
17.
Install rocker arm shaft assembly and tighten bolts in sequence as shown in Fig. 36 and 37.
18.
Install camshaft pulley and bolt. Tighten bolt just enough to allow the pulley to be turned smoothly by hand.
Fig. 15 Timing belt installation sequence
19.
Install new timing belt using sequence shown in Fig. 15. Ensure that belt cogs are properly installed in pulleys. Do not disturb crankshaft setting.
Fig. 16 Semi-tightening sequence of tension pulley
20.
Concentrate belt looseness on tension pulley, depress tension pulley with finger and install tension spring. Semi-tighten bolts in numerical
sequence 1 and 2 to prevent movement of tension pulley, Fig. 16.
21.
Tighten camshaft pulley bolt.
22.
Remove injection pump pulley lock bolt and camshaft fixing plate.
23.
Install crankshaft damper pulley, ensure No. 1 cylinder is at TDC.
24.
Ensure injection pump pulley mark is in alignment with mark on plate and fixing plate fits smoothly into the rear slit of the camshaft. Remove
plate.
