Oasis S L4-2253cc 2.3L SOHC VTEC MFI (1998)
Figure 1: Discard the cotter pin and remove the castle nut.
3.
Remove the cotter pin and castle nut from the lower ball joint. (Figure 1)
^
Discard the cotter pin.
4.
Separate the lower control arm using suitable method.
^
Special tool illustrated in the Workshop Manual is not required.
IMPORTANT
Once separated from the lower arm, do not allow the knuckle assembly to hang by it's own weight, or ABS sensor may become damaged
5.
Remove the axle from the front wheel hub.
^
Tap the end of the axle with a rubber mallet to loosen.
Figure 2: Insert a block of wood to keep the assembly up.
6.
Lift the knuckle, then place a block of wood (approximately 2-3/4" x 1-1/2" x 5") between the upper control arm and the damper assembly. (Figure
2)
7.
Remove (4) brake hose mounting bolts.
^
There are two bolts at the knuckle and two bolts at the damper tube.
