Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Air Door: Service and Repair
Heater Mode Control Link Unit
REMOVAL
Preparation:
Battery ground cable
Drain engine coolant
Discharge and recover refrigerant (W/Air conditioning)
1. Heater unit
2. Case (Mode control)
-
Remove the case (Mode control) from heater unit.
3. Washer and mode main lever
4. Rod
5. Mode sub-lever
-
Press the tab of the sub-lever inward, and take out the sub-lever.
6. Door lever
-
Pull out the door lever while raising up the catch of the door lever.
7. Clip
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following point:
1. Apply grease to mode sub-lever and to the abrasive surface of the heater unit.
HEATER TEMPERATURE CONTROL LINK UNIT