Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
INSPECTION AND REPAIR
Drive Plate
If the frictional surface shows signs of damage due to excessive heat, the drive plate and pulley should be replaced.
Pulley Assembly
Check the appearance of the pulley assembly. If the frictional surface of the pulley shows signs of excessive grooving due to slippage, both the pulley
and drive plate should be replaced. The frictional surfaces of the pulley assembly should be cleaned with a suitable solvent before reinstallation.
Coil
Check coil for loose connector or cracked insulation.
INSTALLATION
7. Field coil
-
Align the located portion of the field coil and compressor.
-
Tighten the mounting screw to the specified torque.
Torque N.m (lb.in.) 5 (44)
6. Lead wire connector
-
Connect the lead wire connector with the rubber hold and tighten the screw.
5. Pulley assembly
-
Using pulley installer (J-33940-A) and drive handle (J-8092) to install the pulley assembly.
4. Snap ring
3. Shim(s)