Rodeo Sport 2WD L4-2.2L (2002)
12. Remove the reclining device covers.
13. Remove the trim cover and pad (Seat back side).
14. Remove the power lumbar support assembly.
15. Remove the guide holder.
-
Pull the guide holder out by holding the bottom end of it from the seat back assembly
16. Remove the seat adjuster assembly.
-
Remove the four fixing bolts and disconnect the sliding motor connector.
17. Remove the sliding motor cable (2).
-
Remove the nuts of each side.
CAUTION: Be sure to maintain the same position for both outer and inner seat adjust assembly (1).
18. Remove the seat belt buckle assembly.
19. Remove the trim cover and pad (Seat cushion side)
20. Remove the power seat harness.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Tighten the reclining device fixing bolts to the specified torque.
Torque: 46 N.m (34 lb ft)
2. Tighten the seat adjuster fixing bolts to the specified torque.
Torque: 21 N.m (15 lb ft) to seat cushion
Torque: 39 N.m (29 lb ft) to body
3. Tighten the seat belt buckle assembly fixing bolts to the specified torque.
Torque: 29 N.m (22 lb ft)
NOTE: The performance of the reclining device and the seat adjuster of a power seat are guaranteed by the set of the outer and inner. Because of this,
make sure to replace the reclining device and seat adjuster by the set.
