Rodeo Sport 2WD L4-2.2L (2002)
-
Before removal, slide the power seat assembly backward.
3. Disconnect the battery ground cable.
4. Remove the power seat assembly.
-
Disconnect the power seat harness connectors and the seat belt warning connector of the driver side.
CAUTION: When raising power seat assembly (1), use the handle (2) not the cable (3). A bent cable causes noise to occur during
power seat operation.
-
Please grip the handle (4).
-
Don't grip the cable (5).
5. Pull the switch knobs out.
6. Remove the outer side cover.
-
Remove the two fixing screws and disconnect the power seat switch connector.
7. Remove the power seat switch.
-
Remove the two fixing screws.
8. Remove the power lumbar switch.
-
Remove the two fixing screws and connectors.
9. Remove the inner side cover.
10. Remove the headrest.
11. Remove the reclining device (2).
-
Flip up the seat back trim cover (1) in order to remove the reclining device fixing bolts.
-
Disconnect the reclining motor harness connector (3).