Trooper LTD 4WD V6-3.5L (2002)
4. Align the alignment mark on the LH bank camshaft drive gear pulley (2) to the alignment mark of the cylinder head cover LH (3).
5. Align the alignment mark (white line) on the timing belt (1) with the alignment mark on the LH bank camshaft drive gear pulley (2).
When aligning the timing marks, use a wrench to turn the camshaft drive gear pulley, then set the timing mark between timing belt and
camshaft drive gear pulley and put the timing belt on the camshaft drive gear pulley. Secure the belt with a double clip or equivalent clip.
Note: It is recommended for easy installation the belt be secured with a double clip or equivalent clip after it is installed to each pulley.
6. Install crankshaft pulley temporarily and tighten center bolt by hand (do not use a wrench).
Turn the crankshaft pulley clockwise to give some belt slack between the crankshaft, timing pulley and the RH bank camshaft drive gear
pulley.
2. Install pusher and tighten bolt to the specified torque.
1. Install the pusher while pushing the tension pulley to the belt.
2. Pull out pin from the pusher.
Note: When reusing the pusher, press the pusher with approximately 100Kg to retract the rod, and insert a pin (1.4 mm piano wire).
3. Remove double clips or equivalent clips from timing belt pulleys.
Turn the crankshaft pulley clockwise by two turns.
Torque: 25 Nm (18 ft. lbs.)
