Vanden Plas (X308) V8-4.0L (AJ27) (2000)
24. Connect wheel speed sensor harness.
Connect wheel speed sensor harness to sensor.
Using new tiestraps secure wheel speed sensor harness to upper wishbone.
25. Install brake calipers.
Remove tie supporting brake caliper.
Install caliper on carrier.
Install guide pins and tighten to 25 - 30 Nm.
Install guide pin dust caps.
Install caliper spring clip.
26. Position and partially tighten wishbone rear eccentric bolt.
Rotate eccentric bolt to align large graduation with mark made during removal.