Vanden Plas (X308) V8-4.0L SC (AJ27) (2001)
7. If the brake disc run-out exceeds specification, reposition the brake disc on the hub and repeat the above procedure. Continue repositioning the
brake disc until the run-out is within specification.
8. If the brake disc run-out still exceeds specification, check the hub face run-out.
9. Remove brake disc.
10. Measure hub face run-out.
^
Position the gauge so that the pointer contacts the hub face.
^
Slowly rotate the hub one revolution, the hub run-out must not exceed the specification.
^
If the hub exceeds the maximum run-out specification replace the hub.
11. NOTE: Make sure the brake disc and hub mating surfaces are clean.
If the hub run-out is within specification replace the brake discs.
12. When the disc run-out is within specification, index mark the hub and disc for future installment.
13. Install caliper to vertical link.
^
Install and tighten bolts to 140 Nm.