XJ (X350) V8-4.2L (2005)
5. NOTE: Front shown, rear similar.
Remove the front air suspension height sensor.
^
Remove the front air suspension height sensor retaining bolts.
Installation
1. To install, reverse the removal procedure.
^
Tighten to 20 Nm.
2. NOTE: To aid installation of the electrical connector, apply a small amount of silicone based oil or grease to the connector seal.
NOTE: Make sure the electrical connector latch is fully secured to the sensor.
Connect the front air suspension height sensor electrical connector.
3. Re-calibrate the suspension height sensor using the Jaguar approved diagnostic system.