XK (X150) V8-4.2L SC (2007)
Installation
1. Install the thermostat housing.
> Clean the components.
> Install a new O-ring seal.
> Tighten the bolts to 10 Nm (7 lb.ft).
2. Install the ECT sensor.
> Clean the component mating faces.
> Install a new O-ring seal.
> Secure with the clip.
3. Install the coolant manifold.
> Clean the components.
> Install new O-ring seals.
> Connect the rear hose and secure with the clip.
> Connect the cylinder block hose and secure with the clip.
> Attach the wiring harness bracket.
> Tighten the Torx screws to 10 Nm (7 lb.ft).
4. Connect the remaining coolant hoses.
> Secure with the clips.
5. Connect the ECT sensor electrical connector.
6. Attach the engine wiring harness.
> Tighten the bolts to 6 Nm (4 lb.ft).
7. Install the supercharger belt.
8. Connect the battery ground cable and install the cover.
9. Refill and bleed the cooling system.