Cherokee 2WD L4-150 2.5L VIN P MFI (1991)
Rear Seat Shoulder/Lap Belts And Buckles
2. Remove the shoulder belt buckle and lap belt/ buckle anchor plate bolts from the floor panel.
3. Remove the shoulder belt lower anchor bolt.
4. Remove the quarter trim panel. If necessary; refer to the removal procedure.
5. Remove the shoulder belt upper anchor bolt.
6. Remove the belt retractor support retaining screw from the rear quarter rail.
7. Remove the retractor and shoulder belt from the trim panel.
INSTALLATION
1. Position the shoulder belt buckle and the lap belt/buckle anchor plates on the floor panel.
2. Install the anchor bolts. Tighten the bolts to 37 Nm (27 ft. lbs.) torque.
3. Position the shoulder belt at the roof rail and install the upper anchor bolt. Tighten the bolt to 37 Nm (27 ft. lbs.) torque.
4. Route the shoulder belt through the quarter trim panel slot. Install the retractor support on the rear quarter rail. Tighten the screw to 5 Nm (45 in.
lbs.) torque.
5. Install the quarter trim panel.
6. Install the shoulder belt lower anchor bolt. Tighten the bolt to 37 Nm (27 ft. lbs.) torque.
7. Return the rear seat cushion to the normal position and engage the latch.
