Cherokee 2WD L6-4.0L VIN S (1998)
Glove Box Lock Cylinder Remove/Install
3. With the key still in the lock cylinder, insert a small pin punch or a stiff wire into the lock cylinder release hole and depress the lock cylinder
retaining tumbler.
4. While holding the retaining tumbler depressed, rotate the key in the lock cylinder clockwise and press outward on the back of the lock cylinder
from the inside of the glove box door until the lock cylinder comes out of the glove box latch lock cylinder bore.
5. To install the lock cylinder, insert the key in the cylinder and align the lock cylinder tumblers with the ramp in the glove box latch lock cylinder
bore. The ramp is located at about the 7 O'clock position.
6. Push the lock cylinder firmly into the lock cylinder bore while rotating the key and cylinder counterclockwise to the 6 O'clock position, where the
lock cylinder retaining tumbler will snap back into place.
