Commander 2WD V6-3.7L (2009)
Control Assembly: Service and Repair
A/C and Heater Control - Installation
Front
INSTALLATION
1. Position the A/C-heater control (4) and the electronic vehicle information center (EVIC) control (3) into the instrument panel center bezel (1).
2. Install the screws (2) that secure the A/C-heater control and the EVIC control to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel onto the instrument panel.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures.
Rear
INSTALLATION
1. Position the rear A/C-heater control (1) near the bezel (3) located in the right interior quarter trim panel (4).
2. Connect the wire harness connectors to the back of the rear A/C-heater control.
3. Install the rear A/C-heater control into the bezel and gently push down on the control until the retainer clips (2) fully engage the slots in the bezel.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool . See: Testing and Inspection/Component Tests and General Diagnostics/HVAC
System Test
