Commander 2WD V6-3.7L VIN K (2006)
Alarm Module: Service and Repair
INTRUSION MODULE
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Fold and tumble the right outboard second row seat assembly forward.
3. Remove the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly (1).
4. Disconnect the body wire harness connector (3) from the intrusion module (2) connector receptacle.
5. Using a trim stick or another suitable wide flatbladed tool, gently pry the two latch features on the floor of the intermediate step cavity away from
the mounting tabs of the module far enough to disengage the module.
6. Disengage the two mounting tabs on the sides of the module from the slots in the intermediate step cavity.
7. Remove the module from the cavity in the intermediate step assembly.
INSTALLATION
1. Position the intrusion module (2) into the cavity on the right outboard end of the intermediate step assembly (1) and insert the two mounting tabs
on the sides of the module into the slots in the floor of the cavity.
2. Slide the module into the slots of the intermediate step cavity, until the two latch features integral to the cavity are fully engaged over the mounting
tabs on the sides of the module.
3. Reconnect the body wire harness connector (3) to the module connector receptacle.
4. Reinstall the carpeted cover panel over the cavity on the right outboard end of the intermediate step assembly.
5. Restore the right outboard second row seat assembly to its normal seating position.
6. Reconnect the battery negative cable.
