Commander 2WD V6-3.7L VIN K (2006)
NOTE: Due to production variations in the bearing, it may not be possible to slide the collar fully downward. It is only necessary to slide the
collar down far enough that the fingers securely grasp the inner bearing race.
8. Slide the collar (3) on the Bearing Remover 9082 (1) downward over the fingers of the tool.
9. Remove the output shaft bearing (3).
CAUTION: Verify that the geartrain end-play shim has remained on the output shaft and against the park gear. The shim may be adhered to the
bearing inner race. Retrieve the shim from the bearing and install over the output shaft and against the park gear.
INSTALLATION
