Commander 2WD V6-3.7L VIN K (2006)
Shifter A/T: Initial Inspection and Diagnostic Overview
NAG1 PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE
Perform the following pre-diagnostic troubleshooting procedures prior to performing any diagnostic test.
Low fluid level can be the cause of many transmission problems. If the fluid level is low, locate and repair the leak then check and adjust the fluid
level.
Always perform diagnostics with a fully charged battery to avoid false symptoms.
1. With the scan tool, read the engine DTCs. Check and repair all engine DTCs prior to performing transmission symptom diagnostic procedures.
2. With the scan tool, read and record all Transmission DTCs.
NOTE: If the TCM detects and stores a DTC, the TCM also stores the vehicles operating conditions under which the DTC originally set and is
located in scan tool under Environmental Data. Before erasing any stored DTCs, it is recommended to record any available data to assist in
duplicating the conditions in which the DTC originally set.
3. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Clean and repair as necessary.
4. Most DTCs set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run.
5. Verify flash level of transmission controller. Some problems are corrected by software upgrades to the transmission controller. Verify that no
variant DTCs are present. If variant DTCs are present, perform their respective test first.
6. If the TCM (EGS) is flashed, perform a EGS initialization with the scan tool to relearn variant coding.
7. Check for any Service Information Tune-ups or Service Bulletins that may apply.
-
If any of the above procedures repaired the customers complaint - testing is complete. Perform NAG1 TRANSMISSION VERIFICATION
TEST See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests
-
If none of the above procedures repaired the customers complaint - Refer to TESTING and perform the appropriate symptom(s).
