Commander 2WD V8-5.7L VIN 2 (2006)
Power Steering Pump: Service and Repair
Removal and Installation
PUMP
REMOVAL
1. Siphon power steering reservoir.
2. Remove the air intake tube.
3. Remove the drive belt.
4. Disconnect the supply hose (2) at the pump (1).
5. Disconnect the pressure line at the pump.
6. Remove the three pump mounting bolts.
INSTALLATION
1. Install pulley on pump if removed.
2. Install 3 pump mounting bolts (1) and tighten to 28 Nm (21 ft. lbs.).
3. Install the pressure hose on the pump and tighten the nut to 28 Nm (21 ft. lbs.).
4. Reconnect the supply hose (2) at the pump (1).
5. Install the drive belt.
6. Install the air intake tube.
7. Fill the system with power steering fluid.
8. Bleed the hydraulic fan system using a scan tool.
