Commander 4WD V8-4.7L VIN N (2006)
1. Position the recirculation-air door (4) into the air inlet housing (1).
CAUTION: Make sure that the recirculation-air door pivot shaft is properly seated in the pivot seats located on the air inlet housing.
2. Install the recirculation door actuator (3) onto the air inlet housing. If necessary, rotate the actuator slightly to align the splines on the actuator
output shaft with those on the recirculation door pivot shaft.
3. Install the two screws (2) that secure the recirculation door actuator to the air inlet housing. Tighten the screws to 2 N.m (17 in. lbs.).
4. Install the air inlet housing onto the HVAC housing.
Front
HOUSING-HVAC ASSEMBLY
DISASSEMBLY
NOTE: The HVAC housing must be removed from the vehicle and disassembled for service of the A/C evaporator.
1. Remove the HVAC housing assembly and place it on a workbench.
2. Remove the air distribution housing (3) from the HVAC housing (1).
3. Remove the air inlet housing (2) from the HVAC housing.
