Commander 4WD V8-4.7L VIN N (2006)
4. Disconnect the HVAC wire harness (1) from the evaporator temperature sensor (2) and the blower motor resistor or power module (4) (depending
on application).
5. Disconnect the wire harness for the blower motor (3) from the blower motor resistor or power module (depending on application).
6. Disengage the two HVAC wire harness retainers from the HVAC housing (5) and remove the wire harness.
7. Remove the blower motor.
8. Remove the blower motor resistor or power module, depending on application.
9. Remove the evaporator temperature sensor.
10. Remove the two bolts (1) that secure the A/C expansion valve (2) to the evaporator tube tapping block (3) located at the front of the HVAC
housing (4).
11. Remove the A/C expansion valve from the evaporator tube tapping block and remove and discard the O-ring seals.
12. Install plugs in, or tape over the opened evaporator tube fittings and all expansion valve ports.
