Commander 4WD V8-4.7L VIN N (2006)
2. Install and tighten the screw (4) that secures the SKREEM mounting bracket to the housing. Tighten the screw to 2 N.m (20 in. lbs.).
3. Reinstall the ignition key cylinder, lock housing and switch (3) into the instrument panel as an assembly.
4. Reconnect the battery negative cable.
NOTE:
-
On vehicles equipped with the optional Sentry Key Immobilizer System (SKIS), when the SKREEM is replaced with a new unit, a
diagnostic scan tool MUST be used to initialize the new SKREEM and to program at least two Sentry Key transponders before the vehicle
can be operated.
-
On vehicles equipped with a premium Tire Pressure Monitoring (TPM) system, when the SKREEM or the spare tire pressure sensor is
replaced with a new unit, a diagnostic scan tool MUST be used to run a routine that allows the SKREEM to be programmed with the ID
number and location of the spare tire pressure sensor mounted in the wheel of the spare tire. Follow the programming steps outlined in the
diagnostic scan tool for Learn Spare Tire Sensor ID under Miscellaneous Functions for the WCM/Wireless Control Module menu item as
appropriate. In addition, if the SKREEM is replaced, the spare tire must be dismounted from its wheel to access and note the ID number on
the spare tire pressure sensor so that the ID code for that sensor can be programmed into the new SKREEM.
