Commander 4WD V8-4.7L VIN N (2006)
1. Engage the front of the buckle anchor plate (3) under the tabs (5) at the front of the left center seat support bracket (2) and position the anchor
plate and both buckles from to the outboard side of the seat support bracket as a unit.
2. Install and tighten the screw (4) that secures the anchor plate and buckles to the left center seat support bracket. Tighten the screw to 50 N.m (37
ft. lbs.).
3. Install and tighten the nut (1) onto the stud (6) that secures the front of the buckle anchor bracket and the left center seat support bracket to the rear
floor panel. Tighten the nut to 50 N.m (37 ft. lbs.).
4. Engage the center seat belt buckle through the elastic loop (3) on the center seat cushion trim.
5. Restore the second row left outboard seat to its seating position.
