Commander 4WD V8-4.7L VIN N (2006)
Seat Belt Buckle: Service and Repair
Second Row - Right
SECOND ROW - RIGHT
WARNING: TO AVOID PERSONAL INJURY OR DEATH, DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT
ANCHOR SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER
STRAPS, AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT,
FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT
THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED
LATCH PLATE OR ANCHOR PLATE. REPLACE ANY CHILD RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR IS
INTEGRAL THAT HAS BEEN BENT OR DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT
COMPONENT. ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE
CORRECT, NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE DAIMLERCHRYSLER MOPART PARTS CATALOG.
REMOVAL
1. Fold and tumble the second row right outboard seat forward against the front seat for easiest access to the seat latch striker trim (4) and the right
center seat support bracket trim (5).
2. Remove the two screws (1) that secure the trim over the right seat inboard latch striker.
3. Unsnap the right center seat support bracket outer trim from the inner trim, then remove it and the striker trim from the seat as a unit.
4. Remove the screw (3) that secures the second row center seat belt lower anchor (2) to the right center seat support bracket.
5. Remove the upper screw (3) that secures the second row right buckle (1) anchor plate to the right center seat support bracket.
6. Remove the right buckle and anchor plate from the seat as a unit.
INSTALLATION
