Compass 2WD L4-2.0L VIN 0 (2007)
11. Turn the upper mounting bracket or shock absorber as necessary until the mounting studs on the mounting bracket line up with the lower mounting
bolt eyelet at the bottom of the shock absorber.
12. Slowly release the tension from the coil spring by backing off the compressor (1) drive completely.
13. Remove the shock assembly from the spring compressor.
14. If equipped, install the noise abatement cap on top of the shock assembly.
15. Install the shock assembly on the vehicle.
Installation
INSTALLATION
1. Insert the lower end of the shock assembly (2) down though the lower control arm from above just enough to clear the body, then lift it up into the
body bracket (1).
