Compass 2WD L4-2.4L (2008)
Clutch Disc: Service and Repair
Clutch Disc - Installation
INSTALLATION
DIESEL
WARNING: DaimlerChrysler does not manufacture any vehicles or replacement parts that contain asbestos. Aftermarket products may or
may not contain asbestos. Refer to aftermarket product packaging for product information. Whether the product contains asbestos or not, dust
and dirt can accumulate on manual clutch parts during normal use. Follow practices prescribed by appropriate regulations for the handling,
processing and disposing of dust and debris
1. Inspect clutch release bearing and lever for excessive wear and replace as necessary. The release bearing is integral to the Concentric Slave
Cylinder (CSC).
2. Clean the surfaces of the flywheel (1) and pressure plate to make certain that all oil, grease, and rust have been removed.
3. Verify the crankshaft mounting flange is free of debris, oil, grease, etc. Position the flywheel (1) onto the engine crankshaft.
4. Install flywheel to crankshaft. Install eight (8) flywheel-to-crankshaft bolts and tighten to 45 Nm (33 ft. lbs.) plus an additional 1/4 turn (90
degrees).
