Grand Cherokee 2WD L6-4.0L VIN S (1997)
Lower Ball Joint Remove/Install
1. Position tools as shown to remove and install ball joint.
KNUCKLE INSTALLATION
1. Position the steering knuckle on the ball joints.
2. Install and tighten the bottom retaining nut to 109 Nm (80 ft. lbs.) torque. Install new cotter pin.
3. Install and tighten the top retaining nut to 101 Nm (75 ft. lbs.) torque. Install new cotter pin.
4. Install the axle shaft.
5. Install the hub bearing.
6. Install the tie rod on the left steering knuckle. Install the tie rod and drag link end on the right steering knuckle.
7. Install wheel and tire assembly.
8. Remove support and lower vehicle.
