Grand Cherokee 2WD L6-4.0L VIN S (1997)
ASSEMBLY
1. Apply Extreme Pressure (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores to aid in installation.
2. Fit a cross into the propeller shaft yoke.
3. Place a bearing cap over the trunnion and align the cap with the yoke bore. Keep the needle bearings upright in the bearing assembly. A needle
bearing lying at the bottom of the cap will prevent proper assembly.
4. Press the bearing cap into the yoke bore enough to install a snap ring.
5. Install a snap ring.
