Grand Cherokee 2WD V6-3.7L (2008)
Rear Door Latch: Service and Repair
Rear Door Latch - Removal
REMOVAL
1. Remove the watershield (1) as necessary to gain access to the latch. See: Rear Door Panel/Service and Repair/Rear Door Watershield/Removal
2. Disconnect the actuator rod (1) from the exterior handle (2).
3. Disconnect the interior handle actuator rod from the rear door latch (3) and remove the rod.
4. Remove the three bolts (1) that secure the rear door latch to the door and remove the latch and actuator rods as an assembly.
5. Disconnect the door wire harness connector (2) from the rear door latch.
6. If required, remove all of the actuator rods from the actuator.
